rangerovers.pub
The only place for a coil spring is up Zebedee's arse.
Member
Joined: Jul 12 2016
Posts: 725

If this fails would it show -20 degrees in Nanocom?

Mine is showing -20 degrees.

Member
avatar
Joined: Dec 30 2015
Posts: 3077

Yes, it's open circuit.

Member
Joined: Jul 12 2016
Posts: 725

And, based on the name, I'm guessing it's in the side of the heater core in the depths of the dashboard?

Member
avatar
Joined: Dec 30 2015
Posts: 3077

It's the one clipped to the inlet pipe next to where the O rings live. The clip can break so it falls off the pipe and just dangles so reads ambient temperature. I know it's been cold but I doubt it got that cold.......

Member
Joined: Jul 12 2016
Posts: 725

Sounds like an ideal candidate for when I replace my blower motors. Might as well pre-emptively do the o-rings while I'm there!

Going to be a busy year under/in the P38 this year!

Ball joints, heater stuff, suspension bushes...

Member
avatar
Joined: Jan 05 2016
Posts: 832

Bastard clip is a pain to get back on... it will probably snap when you do. If it does... cable tie.