I've just replaced my ABS modulator after fitting Russell's BMR kit. Now I'm having difficulty bleeding the system.

After following the bleeding procedure the ABS pump now just runs continuously and never stops, the pedal also goes all the way to the floor and barely stops the car. The reservior level doesn't seem to go down at all when the pump is running.

I'll try the bleed procerure again in the morning but is there anything obvious I'm missing?

Thanks.

I bled mine yesterday after doing some work on the modulator and it all bled up lovely with a nice firm pedal. Until I was just finishing off the last bleed nipple (nearside front caliper on the pressure system). Suddenly the pedal went 'limp' and no fluid was being pushed out.

A quick check re-bleed of the master cylinder bleed point on the modulator unit (lower forward one, the first one you bleed) released a slug of air that had found its way in there. Once clear again full system operation was restored.

I'm not saying that this is the same as your problem but it might be worth a go.

How are you bleeding it, two people or easy bleed ?

Easy bleed won't work...... You have to follow the process.