Is there any way to tension/tighten up the bonnet/hood release cable(s)?
Looking at images of newer ones it appears that the end tabs are fixed so not much hope in adjusting there but wondering if there may be a fix…
Mines a little too slack for my liking when I go to release bonnet/hood.
Are the older ones prone to stretching over time?

Edited……. Just popped back out to look at cable…. Requires replacement…. Cable on pax side has frayed and is causing latch not to close.
Replacement ordered.
Probably should have reviewed item prior to posting question…..
Carry on…. I’ll let myself out……

Not that I know of, unless there's any adjustment at the lever end. There definitely isn't at the latch end.

Thanks for reply GILBERTD….
Seems my P38 is having fits in threes….
Exhaust system failed, mysterious oil disappearance followed by hood latch cables fraying……
Fortunately I can attend to them all and the cost of purchase is only outlay.