rangerovers.pub
The only place for a coil spring is up Zebedee's arse
Member
Joined:
Posts: 27

Hi everyone, I just acquired a 2001 4.0 HSE P38 as a non runner.

It had stood for 2 years or so but I have managed to get it to start.

It was parked up as the EAS had stopped working and the owner intended to put it onto springs but had lost interest in it.

I'd like to get the EAS up and running and using the very helpful Beginners guide to EAS have established that the thermal cutout in the pump has failed.

Can anyone advise where I can get hold of one please?

I can buy them from Mouser online at about £4 each but it's £12 P&P on top. If I have to but it from them does anyone else want one as a spare aso w ecan split the shipping costs?

Member
avatar
Joined:
Posts: 7757

https://www.ebay.co.uk/itm/273885002302 or, so you can test it, jumper between the orange and black wires.

However, if the thermal cutout has tripped and stayed tripped, chances are the compressor needs a new sleeve and seal. It will have been working but not very well so the motor overheated causing it to trip out.

Member
Joined:
Posts: 27

Thanks Gilbert. Don';t know how I missed that one on Fleabay.

I've ordered a pump repair kit and block seals and will work my way through the system.