Hi All,

I am aware of the torque setting information in Rave but for example I replaced the fan belt tensioner ram and idler pulleys today. There are no torque setting I could see on Rave for these items.

So what do you all do? Tension to 25nm?

If there's not a torque setting listed in the instructions for the tensioner then there's a section at the beginning of the manual that states general torque settings for each size of bolt. If you know the size of the bolt you can use the torque value there.

I can't remember the page/section number and don't have access to RAVE at the moment though, sorry.

This is the page I meant