rangerovers.pub
The only place for a coil spring is up Zebedee's arse
Member
Joined:
Posts: 11

Ok, so rewind a few weeks, I offered to get some 3D printed parts made to fit new microswitches for P38 door latches. My son has printed 20 of them, although I would still like him to print some of the blanks - plastic blocks that you can fit where you don't need a microswitch on latches that aren't for the drivers door.

I'll post some pics of the 3D printed parts and show them assembled with the switches and fitted to a latch. It is a fiddly job, but not that bad for anyone who likes a small DIY challenge!

The cost of making them is very low, so we're just looking to recoup postage and packing costs.

Let me know if you're wanting some, I think Richard (Gilbertd) and romanrob have asked for some so far

Member
Joined:
Posts: 170

Me please.
Ta.

Member
avatar
Joined:
Posts: 7756

Yes please, 3 for me if possible.

Member
Joined:
Posts: 170

Chrisp38 wrote:

Me please.
Ta.

Assumed it was 20 sets of 3 printed?
So I'd like a latch set of 3 same as Richard please.

Member
avatar
Joined:
Posts: 7756

I'm assuming this is a cage to hold 3 microswitches in place inside the latch mechanism. I need 3 as I've got a latch with an iffy keyswitch in the Ascot and 2 duff latches sitting on the bench waiting to be done. Might as well do them all then I'll at least have spares.

The blanks probably won't be needed unless they are to go in the space that a microswitch would go if it was needed. The passenger latch on a P38 still has all 3 switches even though only 2 of them are needed, the CDL and the door ajar switch. The MGTF passemger latch only has a door ajar switch though even though the drivers latch is identical to the P38 one.

Member
Joined:
Posts: 766

Thanks so much...

Do you have PayPal? Pm me your email and i'll drop you a fiver for pnp

Member
Joined:
Posts: 170

Anybody heard anything?

Member
Joined:
Posts: 766

nada