rangerovers.pub
The only place for a coil spring is up Zebedee's arse
Member
Joined:
Posts: 248

The front passenger door bass/woofer speaker commenced ‘buzzing’ a sound I have heard many times before. No problem, I have a spare (repaired following the last time a door woofer ‘let go’ and was replaced) so off with the door card, swap out the speaker and and away we go - all good.

I then examined the recalcitrant speaker expecting to see the usual cone coming away from its surroundings or, worse still, a split cone. But no, the speaker looks pristine and the cone, even after 25 years of service, is completely intact and firmly attached all round. I can find no issue with it!

So, the question is what could possibly be the problem with it or could it be just a bad connection which was solved by disconnection/reconnection of the speaker connector. Anyone know of a quick way to test it (without pulling a door card and reconnecting it)?

Member
avatar
Joined:
Posts: 8643

Does the cone move freely? I've known then to seize completely so the speaker looks fine but doesn't move.

Member
Joined:
Posts: 249

Just connect the speaker to the headphone output on a Laptop & play some audio through it.

Member
Joined:
Posts: 289

I tested for a free moving cone by touching the 2 terminals briefly with a 9v pp9 battery, swop the battery round to move the cone the other way. Most of mine were seized.

Member
Joined:
Posts: 248

Thanks for the responses. Cone moves freely in and out but sounds a bit ‘rough’. Need to play something through it so, as per Pete’s suggestion, I’ll rig up a phono jack and wires and play some select music through it.

Member
Joined:
Posts: 248

So, having found the correct jack sized jack plug I’ve connected the errant speaker up to audio sources and . . . . it’s absolutely fine???

I’m at a loss now to explain the problem as the replacement is working fine in the vehicle and the removed one is working fine on the bench!!!

Member
Joined:
Posts: 249

Chances are there's some corrosion around the coil which was scraping on the magnet. You could try holding the speaker in different orientaions while playing audio through it ?

But replacements are relatively cheap it's not really worth fixing.

Member
Joined:
Posts: 248

I've tried it in all orientations and it seems fine. I think it may well have been a problem twixt coil & magnet as it did seem a little rough when manually manipulated - a bit of exercise may have loosened things up. I may try hooking it up to a Sonos amp which will be able to give it more 'oomph' than my PC could and see if its still OK.

As for buying v fixing things . . . shame on you . . . we have P38s, fixing is what we do . . . continually!

Edited to add : The condition of the speaker after over 25 years in a door is quite remarkable, externally it still looks like new!