rangerovers.pub
The only place for a coil spring is up Zebedee's arse
Member
Joined:
Posts: 1141

Smiler wrote:

Now that's interesting, I have an old hard drive kicking around here that sudddnly stopped 'existing'...

if it still spins your in with a chance, if the motor doesn't feel like its running your less likely to get success.

Its good for retrieving otherwise lost info, but i wouldn't trust the drive with anything important after its done that sort of thing, they have a habbit of doing the same again!

Member
Joined:
Posts: 426

Its an SSD. I shall try the suggestions when I get back from my weekend away visiting the in-laws...

Member
Joined:
Posts: 1141

Smiler wrote:

Its an SSD. I shall try the suggestions when I get back from my weekend away visiting the in-laws...
Ah, I'd be less optermistic that being the case. Quite a few i've known to be fine, then you reboot the machine and its gone forever. less well known brands seem more prone to failing like that (one customer we work with decided to rollout a load - Hypertec i think. Within 3 months we had to go back and swap them all out as they started failing en masse and swapping them out for Samsung ones instead). Still no harm in trying though.

Member
Joined:
Posts: 1301

I might have a couple of pictures, but I think they were general pictures...

I'll try to remember to have a look tomorrow and if I find anything, and I'll let you know...

Member
Joined:
Posts: 995

Orangebean wrote:

I was thinking more like this, with the caption "Make sure that your work table is easily accessible,your surroundings are spotlessly clean and you wear suitable protective clothing"
enter image description here

:)

Do you want me to email the original (full version) Smiler? If so, pm me your email address

HOW TALL IS THIS GUY??

I might need to start paying more attention to the headlining stories and photos....found mine beginning to sag over the weekend :(

Member
avatar
Joined:
Posts: 7822

You should have said, we did the one in the Ascot on Monday, you could have called round and seen how it's done.

Member
Joined:
Posts: 995

I've been a tad busy the last two weeks - my little boy was born on the 12th and I think abandoning him and his mummy to go looking at car stuff would have been frowned upon :P

I'm back at work now, which is how I've found time to start looking forums again.

Member
avatar
Joined:
Posts: 7822

Congrats, now you've got an apprentice. Having someone with little hands is always useful.