rangerovers.pub
The only place for a coil spring is up Zebedee's arse
  1. Forum
  2. Range Rover P38
  3. Electrickery
  4. Help! Coil/ HT lead configuration
Help! Coil/ HT lead configuration

Orangebean

Member
Joined:
Posts: 2312
(Last modified: by Orangebean)
#1

Like a cheapskate, I bought 2 single coil packs for the SE rather than the bracketed version. Only problem is, the HT/ cylinder lead numbering is identical on each (1,2,3,4), which isn't a great help!

enter image description here

Do I just wire them as per the published RAVE picture?
enter image description here
The input plugs look identical in every respect so can't see any issue there.
Thanks in advance
Mark

rayodunne

Member
Joined:
Posts: 118
(Last modified: by rayodunne)
#2

Remove the bracket with coils and wires attached. Place on bench and swap everything over. You have to install new coils on the bracket anyway.
On LHD truck without SAI you can pull the whole assemply out on the right hand side. Not sure if that will work with RHD.

Ferryman

Member
Joined:
Posts: 647
#3

The lay-out is as pictured, as long as you have one 3-pin input connector at each side it is just as you showed.

Are you sure that you want to perform this action? This action is irreversible.