rangerovers.pub
The only place for a coil spring is up Zebedee's arse
P38Rangey
Member
offline
3 posts
In topic Headlining again, where to repair/replace?

Is there enough material in the Martrim kits to complete both the headlining and the sunroof slide?

In topic Wheel Bearings

I've done all 4 of mine with Timken bearings. Used a 30T press but it didn't go over 8T at any time getting the old one out or putting the new one in.....

In topic The law of unintended consequences

When i did my bushes the 30ton press readout never showed more than 5 ton pressure to get the old bush out and no more than 3 ton to get the new one in. (Genuine Land Rover parts...)