Ok here goes
Leolito, No idea how old the plugs are, They dont look bad, no misfires or codes other than system lean bank1 (right side i think) which is where the white plugs are located. I can post a pic when i figure out how. I have o2 sensor reading for bank 1 only for some reason, not sure about voltage. It reads 96% for the first 20km or so then goes up to 98%. Interestingly though during accel or decell it does not read. Not sure if this helps will look into this more.
Gilbertd, 1 maf sensor right at the air filter, i think 4 o2 sensors (I think this is what you mean by lambda) before and after catalytic each side. More research to be done on this. Ditto on the fuel pressure. Im leaning toward poor/plugged injectors.
mad-as. Fuel pressure is controlled by ecu via a pwm signal, According to the manual it should fluctuate but be a relatively steady 45psi at idle.
Aragorn I need to get a pressure gauge and figure out where it gets hooked up. The injector rail is buried under the intercooler's. I am currently reading pressure from the scan tool, thats why i pulled the plugs. It is a returnless system.I believe the pressure regulator is vacuum referenced since there is a vacuum line running to the intake prior to the supercharger. The absolute pressure reading is approx 5-6psi at idle. I think this is a vacuum since with the engine off it reads 14.5(1bar) Fuel Pressure at hard acceleration is 50- 60psi (3.25-4bar?) Engine is a 4.2L supercharged Jaguar.
I did unload a whole can of WD40 all over the top of the engine looking for vacuum leaks and none were found. I will do a bit more this weekend with vacuum and hopefully a pressure gauge. For right now I have put 3 cans of fuel injector cleaner into the fuel, cleared the engine adaptive values and have not had the code return. Although I believe this is a temporary fix. I will pull the plugs again this weekend to see if there is a change. I expect the code will return at some point in the next few months. I am currently leaning towards poor/plugged injectors. Opinions and suggestions are welcome since I do not want to turn this into a parts cannon.
Sorry guys I have forgotten to check this forum after i realized I posted in the P38 section. Since I cant find an L322 section I assumed this forum was dedicated to P38. I will catch up tonight after work.
I currently am trying to find the cause of system too lean codes. PO0171 and PO0174
A little history
Purchased last year around April PO171 code showed up almost immediately. Cleaned Maf sensor, and put injector cleaner into fuel. That seamed to clear the code until September. Then the code started showing back up intermittently. Stored the truck until spring. Smoke tested intake over winter and found no leaks. When i started driving the truck a week ago both engine lean codes came back. Added injector cleaner to fuel that cleared the bank 2 (P0174) code but the bank 1 (P0171) comes back. There are no other engine codes shown. I started watching some live values while driving the fuel pressure fluctuates a bit at idle and while cruising at 2000 RPM. It falls to 41psi at times. and then quickly recovers. It does increase to about 55-60 psi under harder acceleration.
Today I removed the spark plugs and the front three spark plugs of bank1 (right side not sure what the cyl numbering is) are white compared to the rest which are a nice light brown.
Im trying to determine if the injectors are partly plugged or the fuel pump is possibly getting weak. It does not run rough or stumble when driving.
Scan tool is a IID tool
2008 Range Rover Supercharged Canadian vehicle