rangerovers.pub
The only place for a coil spring is up Zebedee's arse
  1. Forum
  2. Range Rover P38
  3. Electrickery
  4. New Compressor?
New Compressor?

Bolt

Member
Joined:
Posts: 377
#1

Well, I seem to have pretty much run through all of the possible combinations of parts from 4 compressors to make good ones....
My 2 Frankenstein units are going OK, but I don't trust the stator on one of them.
So, I am going to bite the bullet and buy at least one new unit.
What is the latest bestest compressor to buy? Thomas 327 and retrofit? Viair? which one?
OEM Dunlop branded??
Next question is from where? Anyone got a lead on good pricing?
Rimmer seems to have the lowest on Dunlop even with shipping.....
Any advice is, as always, greatly appreciated!

Gilbertd

Member
avatar
Joined:
Posts: 8080
#2

Don't buy the Dunlop branded one. They appear identical to the original Thomas (except the pump housing is plain alloy and not painted black) but don't seem to last more than a couple of years. Not sure who makes them but Dunlop certainly don't make compressors. If I needed one I'd go for a used original and budget for a new seal and sleeve.

Bolt

Member
Joined:
Posts: 377
#3

Well, That's basically what I have been doing since Day 1 and on through all 6 P-38s that I have had.
Now, I am dealing with commutators that are knackered and cannot be cleaned up any further.
I am afraid that any used one may have the same issues......
PaulP38's page has a Thomas retrofit. Seems like a fair swap, and about the same money for the Thomas 327 as the
"Dunlop" which, is pictured everywhere with a black body and a friendly yellow "Dunlop" sticker.
Didn't know if that was a Thomas or not.

Bolt

Member
Joined:
Posts: 377
#4

Update:
Installed the Thomas. A bit Larger as expected, so the lid does not quite fit.
A LOT more air though, so satisfactory.
Unless a verifiably good quality replacement shows up, I will probably do it again to the HSK.
A bit disappointing though as Thomas does not offer a piston kit for this compressor.
They said they should last many years.....Yea? so what, I want to rebuild, not replace!
Has anyone been able to find a service kit that fits?

Morat

Member
Joined:
Posts: 2441
(Last modified: by Morat)
#5

£464? that seems a little spicey... do they have a big upside?

Bolt

Member
Joined:
Posts: 377
(Last modified: by Bolt)
#6

The larger Thomas compressor was USD$322.00
A bit less than the "Dunlop" branded ones, and USA made. A significant improvement in output as well.
Be nice if it was also serviceable. I am looking for equivalent parts for that.

Gilbertd

Member
avatar
Joined:
Posts: 8080
#7

The Dunlop branded one is cheaper in the UK while the Thomas is more expensive, so it will depend on where in the world you are which is cheaper.

Are you sure that you want to perform this action? This action is irreversible.